Fixed:

1. Fixed laser cutting not emitting light after engraving in some cases
2. Fixed failing to resume after pause

Added:

1. Added support for Beam Air auto On/Off with USB cable
2. Added 17% power threshold, any power setting lower than 17% will be forced to 17%
   • NOTE: The power rate on the LCD panel still apply under 17%
   • NOTE: After 3.2.4, this threshold will be restricted to Beamo model only
3. Added origin-relocate feature, allow to adjust file origin position on machine
4. Added German into supported languages
5. Added closing pump and restricting ventilator power during working of Diode laser
6. Added non-volatile setting of motor direction for Beamo model